Non-uniform shades of colour on any one sign will not be accepted. written warranty that the fluorescent colours shall be durable for a minimum 3 years for temporary signs.Īll retro-reflective sheeting used on the same sign shall be carefully matched for colour to produce a uniform appearance both by day and by night. The retro-reflective sheeting manufacturer shall furnish the S.O. a letter of warranty for the specified period for all sign faces from the manufacturer of the sheeting or the sign fabricator.
The finish of all sign faces shall be capable of passing the tests described in MS 1216, and and standard of fabrication and workmanship shall be such that under normal conditions of service and proper maintenance, the sign faces shall last not less than 5 years without any seriousblemishes or defects for Engineering Grade retro-reflective sheeting and 8 years for High Intensity and prismatic retro-reflective sheeting. They shall be applied in accordance with the sheeting manufacturer’s instruction. Any cut-outlet letters, numerals, symbols and borders shall be of material compatible with the sheeting to which they are applied. Where shetting is applied to the extruded section by pressure roller, it shall extend over the top and bottom edges of this sections by not less than 3 mm. it shall be free from twists, cracks, folds or cuts, air bubbles and other blemishes. Retro-reflective sheeting shall be applied evenly over the whole surface of the sign plate and shall adhere fully. The overlap in the horizontal joint shall be from the top and the vertical joint shall be from the left but joints will be only be accepted for prismatic retro-reflective sheeting. Only vertical and horizontal joint shall be permitted and all join in retro-reflective shetting shall be overlapped by not less than 6 mm.
All faces up to 1 m in size shall be produced with a single sheet and no joint will be accepted. Where, with the aggrement of the S.O., more than one retro-reflective sheeting is used, the number of sheets shall be kept to a minimum. Unless otherwise agreed by the S.O., sign faces shall be formed from a single piece of retro-reflective sheeting. All retro-reflective sheeting shall be fixed in accordance with the manufacturer’s instruction. 2 This Addendum shall be made part of the ‘JKR Standard Specification For Roads Works’ 6.2.5.5 Sign Faces Sign faces for permanent traffic sign shall be as shown on the Drawing and shall comply with the Malaysian Standard Specification for Reflective Sign Faces Materials (MS 1216). Table 4.9- Design Bitumen Contents Clause 4.2.4.3, page S4 - 23 should read as follows :ĪCW 20 - Wearing Course ACW 28 - Binder CourseĪDDENDUM NO. Gradation Limit For Asphaltic Concrete Clause 4.2.4.2, page S4 – 21 should read as follows :Ģ. 1 This Addendum shall be made part of the ‘JKR Standard Specification For Roads Works’ 1. KETUA PENGARAH KERJARAYA JABATAN KERJARAYA MALAYSIA JALAN SULTAN SALAHUDDIN 50582 KUALA LUMPURĪDDENDUM NO. KERAJAAN MALAYSIA JABATAN KERJA RAYA MALAYSIAĬAWANGAN JALAN IBU PEJABAT JABATAN KERJARAYA MALAYSIA JALAN SULTAN SALAHUDDIN, 50582 KUALA LUMPUR.
Roads Branch Public Works Department Malaysia Jalan Sultan Salahuddin 50582 Kuala Lumpur